Capt. Lahti
06-14-2011, 01:05 PM
Just acquired the above pistol and after some tinkering last night got it re-assembled so it would cycle the hammer in double action but it still won't cycle the cylinder nor will it drop the hammer in single action. Had to replace a lost sear spring with one from a ball point pen but there still seems to be something missing or mis-aligned. Exteriorly it dosen't look like it's had much use though someone was kinda hard on putting some of the pins back in and may have used a nail or two for some pin replacement.
Looking for suggestions or schematics or a source for parts short of me remaking some parts from scratch. Anyone out there to give me any help? Sure would appreciate it. It's sure be fun to get it making smoke again. Thanks.
Capt. Lahti'
Looking for suggestions or schematics or a source for parts short of me remaking some parts from scratch. Anyone out there to give me any help? Sure would appreciate it. It's sure be fun to get it making smoke again. Thanks.
Capt. Lahti'